The best perimeter edge in the industry!

Measuring your bra size:

First, using a seamstress tape, measure around your ribs (just below your bust) keeping the tape snug - not tight.

Next, add 4-inches to your measurement to determine your bra size. If your total is an odd number, then round up to the next inch because bras are only available in even numbered sizes.

Example; rib measurement equals 35-inches; plus 4-inches equals 39-inches, which is an odd number. Hence, round up to 40-inches. 40-inches will be your bra size. You can double check this number by measuring just above the chest from the center of the breast bone, under your arm to the center of your spine and multiplying that number by 2.

FemForm sizes:

C-cup, 4.25"W X 5.25"H X 2.25"D
D-cup, 4.50"W X 5.50"H X 3.00"D
DD-cup, 5.25"W X 6.25"H X 3.25"D
E-cup, 5.50"W X 6.50"H X 4.00"D

FemForm Implants:

D-cup 'tear drop' only (photo below: click to enlarge)


Adhering breast forms to the skin can be greatly assisted with the use of our FemMix adhesive. FemMix is a two part glue, which temporarily adheres all of our prosthetics directly to human skin - without affecting their ability to flex and move naturally.

The proper FemMix ratio is 1-part A, plus 1-part B (by volume). After mixing A and B together, spread the mix evenly onto a flat piece of glass, laminate or plastic. Next, lay the back side of one breast form onto the glass and ensure that an even coating of the mix is applied, then position the form above your own breast and hold it in position for five minutes while the FemMix cures. Repeat the process for the opposite breast.

Note: FemMix cures rapidly, so only mix enough for one breast at a time.

To remove FemMix, slowly peel the prosthetic away from the skin and slowly peel the FemMix off of the Prosthetic.


© 2019 Specialty Mold Works Corp.